Commit 56940906 authored by Matthias Brugger's avatar Matthias Brugger
Browse files

ARM: defconfig: add unified config for RPi3 and RPi4



Provide a defconfig which allows us to boot Raspberrry Pi 4
and Raspberry Pi 3 Model B/B+
Instead of using the embedded DTB as done in RPi3 we use the
devicetree provided by the firmware.
Signed-off-by: default avatarMatthias Brugger <mbrugger@suse.com>
parent 917a1e9a
...@@ -188,6 +188,13 @@ config TARGET_RPI_4 ...@@ -188,6 +188,13 @@ config TARGET_RPI_4
This option creates a build targeting the ARMv8/AArch64 ISA. This option creates a build targeting the ARMv8/AArch64 ISA.
select BCM2711_64B select BCM2711_64B
config TARGET_RPI_ARM64
bool "Raspberry Pi one binary 64-bit build"
help
Support for all armv8 based Raspberry Pi variants, such as
the RPi 4 model B, in AArch64 (64-bit) mode.
select ARM64
endchoice endchoice
config SYS_BOARD config SYS_BOARD
......
CONFIG_ARM=y
CONFIG_ARM64=y
CONFIG_TARGET_RPI_ARM64=y
CONFIG_ARCH_BCM283X=y
CONFIG_SYS_TEXT_BASE=0x00080000
CONFIG_SYS_MALLOC_F_LEN=0x2000
CONFIG_DISTRO_DEFAULTS=y
CONFIG_NR_DRAM_BANKS=2
CONFIG_OF_BOARD_SETUP=y
CONFIG_USE_PREBOOT=y
CONFIG_PREBOOT="usb start"
CONFIG_MISC_INIT_R=y
# CONFIG_DISPLAY_CPUINFO is not set
# CONFIG_DISPLAY_BOARDINFO is not set
CONFIG_SYS_PROMPT="U-Boot> "
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_GPIO=y
CONFIG_CMD_MMC=y
CONFIG_CMD_USB=y
CONFIG_CMD_FS_UUID=y
CONFIG_OF_BOARD=y
CONFIG_ENV_FAT_INTERFACE="mmc"
CONFIG_ENV_FAT_DEVICE_AND_PART="0:1"
CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG=y
CONFIG_DM_KEYBOARD=y
CONFIG_DM_MMC=y
CONFIG_MMC_SDHCI=y
CONFIG_MMC_SDHCI_BCM2835=y
CONFIG_PHYLIB=y
CONFIG_DM_ETH=y
CONFIG_PINCTRL=y
# CONFIG_PINCTRL_GENERIC is not set
# CONFIG_REQUIRE_SERIAL_CONSOLE is not set
CONFIG_USB=y
CONFIG_DM_USB=y
CONFIG_USB_DWC2=y
CONFIG_USB_KEYBOARD=y
CONFIG_USB_HOST_ETHER=y
CONFIG_USB_ETHER_LAN78XX=y
CONFIG_USB_ETHER_SMSC95XX=y
CONFIG_DM_VIDEO=y
CONFIG_SYS_WHITE_ON_BLACK=y
CONFIG_CONSOLE_SCROLL_LINES=10
CONFIG_PHYS_TO_BUS=y
CONFIG_OF_LIBFDT_OVERLAY=y
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment