Commit da798851 authored by Bob Beckett's avatar Bob Beckett
Browse files

board: ge: bx50v3: add i2c eeprom bootcount storage



Add bootcount node, linking to i2c eeprom "bootcount" partitions for
storage.
Enable i2c eeprom bootcount backend storage.
Enable bootcount command and use it for failbootcmd.
Signed-off-by: Bob Beckett's avatarRobert Beckett <bob.beckett@collabora.com>
parent 158f11bc
......@@ -5,6 +5,11 @@
*/
/ {
bootcount {
compatible = "u-boot,bootcount-i2c-eeprom";
i2c-eeprom = <&bootcount>;
};
wdt-reboot {
compatible = "wdt-reboot";
wdt = <&wdog1>;
......@@ -20,7 +25,7 @@
size = <1022>;
};
bootcount {
bootcount: bootcount {
offset = <1022>;
size = <2>;
};
......
......@@ -5,7 +5,6 @@ CONFIG_TARGET_GE_BX50V3=y
CONFIG_ENV_SIZE=0x2000
CONFIG_ENV_OFFSET=0xC0000
CONFIG_NR_DRAM_BANKS=1
CONFIG_SYS_BOOTCOUNT_ADDR=0x7000A000
CONFIG_ENV_SECT_SIZE=0x10000
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
CONFIG_FIT=y
......@@ -27,6 +26,7 @@ CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_PCI=y
# CONFIG_CMD_NFS is not set
CONFIG_CMD_BOOTCOUNT=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_EXT2=y
CONFIG_CMD_EXT4=y
......@@ -42,9 +42,9 @@ CONFIG_ENV_IS_IN_SPI_FLASH=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_DM=y
CONFIG_BOOTCOUNT_LIMIT=y
CONFIG_BOOTCOUNT_EXT=y
CONFIG_DM_BOOTCOUNT=y
CONFIG_DM_BOOTCOUNT_I2C_EEPROM=y
CONFIG_BOOTCOUNT_BOOTLIMIT=10
CONFIG_SYS_BOOTCOUNT_EXT_DEVPART="1:5"
CONFIG_DM_GPIO=y
CONFIG_DM_I2C=y
CONFIG_SYS_I2C_MXC=y
......
......@@ -109,9 +109,7 @@
"setcurs 5 4; " \
"lcdputs \"Monitor failed to start. " \
"Try again, or contact GE Service for support.\"; " \
"mw.b 0x7000A000 0xbc; " \
"mw.b 0x7000A001 0x00; " \
"ext4write ${dev} ${devnum}:5 0x7000A000 /boot/failures 2\0" \
"bootcount reset; \0" \
"altbootcmd=" \
"run doquiet; " \
"setenv partnum 1; run hasfirstboot || setenv partnum 2; " \
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment