Commit 80f7228b authored by Adrian Bunk's avatar Adrian Bunk
Browse files

typo fixes: occuring -> occurring


Signed-off-by: default avatarAdrian Bunk <bunk@stusta.de>
parent 47bdd718
......@@ -602,7 +602,7 @@ Consider the following sequence of events:
This sequence of events is committed to the memory coherence system in an order
that the rest of the system might perceive as the unordered set of { STORE A,
STORE B, STORE C } all occuring before the unordered set of { STORE D, STORE E
STORE B, STORE C } all occurring before the unordered set of { STORE D, STORE E
}:
+-------+ : :
......
......@@ -389,7 +389,7 @@ fastcall void __kprobes do_page_fault(struct pt_regs *regs,
/* When running in the kernel we expect faults to occur only to
* addresses in user space. All other faults represent errors in the
* kernel and should generate an OOPS. Unfortunatly, in the case of an
* erroneous fault occuring in a code path which already holds mmap_sem
* erroneous fault occurring in a code path which already holds mmap_sem
* we will deadlock attempting to validate the fault against the
* address space. Luckily the kernel only validly references user
* space from well defined areas of code, which are listed in the
......
......@@ -148,7 +148,7 @@ asmlinkage void do_page_fault(struct pt_regs *regs, unsigned long error_code,
/* When running in the kernel we expect faults to occur only to
* addresses in user space. All other faults represent errors in the
* kernel and should generate an OOPS. Unfortunatly, in the case of an
* erroneous fault occuring in a code path which already holds mmap_sem
* erroneous fault occurring in a code path which already holds mmap_sem
* we will deadlock attempting to validate the fault against the
* address space. Luckily the kernel only validly references user
* space from well defined areas of code, which are listed in the
......
......@@ -268,7 +268,7 @@ static int pmu_set_cpu_speed(int low_speed)
/* Make sure the decrementer won't interrupt us */
asm volatile("mtdec %0" : : "r" (0x7fffffff));
/* Make sure any pending DEC interrupt occuring while we did
/* Make sure any pending DEC interrupt occurring while we did
* the above didn't re-enable the DEC */
mb();
asm volatile("mtdec %0" : : "r" (0x7fffffff));
......
......@@ -175,7 +175,7 @@ static void eeh_report_failure(struct pci_dev *dev, void *userdata)
*
* pSeries systems will isolate a PCI slot if the PCI-Host
* bridge detects address or data parity errors, DMA's
* occuring to wild addresses (which usually happen due to
* occurring to wild addresses (which usually happen due to
* bugs in device drivers or in PCI adapter firmware).
* Slot isolations also occur if #SERR, #PERR or other misc
* PCI-related errors are detected.
......
......@@ -418,7 +418,7 @@ asmlinkage void __kprobes do_page_fault(struct pt_regs *regs,
/* When running in the kernel we expect faults to occur only to
* addresses in user space. All other faults represent errors in the
* kernel and should generate an OOPS. Unfortunatly, in the case of an
* erroneous fault occuring in a code path which already holds mmap_sem
* erroneous fault occurring in a code path which already holds mmap_sem
* we will deadlock attempting to validate the fault against the
* address space. Luckily the kernel only validly references user
* space from well defined areas of code, which are listed in the
......
......@@ -397,7 +397,7 @@ static void handle_errors(struct ipath_devdata *dd, ipath_err_t errs)
if ((dd->ipath_maskederrs & ~dd->ipath_ignorederrs) &
~(INFINIPATH_E_RRCVEGRFULL | INFINIPATH_E_RRCVHDRFULL))
ipath_dev_err(dd, "Disabling error(s) %llx because "
"occuring too frequently (%s)\n",
"occurring too frequently (%s)\n",
(unsigned long long)
(dd->ipath_maskederrs &
~dd->ipath_ignorederrs), msg);
......
......@@ -5592,7 +5592,7 @@ mpt_HardResetHandler(MPT_ADAPTER *ioc, int sleepFlag)
/* The SCSI driver needs to adjust timeouts on all current
* commands prior to the diagnostic reset being issued.
* Prevents timeouts occuring during a diagnostic reset...very bad.
* Prevents timeouts occurring during a diagnostic reset...very bad.
* For all other protocol drivers, this is a no-op.
*/
{
......
......@@ -5358,7 +5358,7 @@ static int ipw2100_set_key(struct ipw2100_priv *priv,
idx, keylen, len);
/* NOTE: We don't check cached values in case the firmware was reset
* or some other problem is occuring. If the user is setting the key,
* or some other problem is occurring. If the user is setting the key,
* then we push the change */
wep_key->idx = idx;
......
......@@ -390,7 +390,7 @@ static int serial_pxa_startup(struct uart_port *port)
/*
* Finally, enable interrupts. Note: Modem status interrupts
* are set via set_termios(), which will be occuring imminently
* are set via set_termios(), which will be occurring imminently
* anyway, so we don't enable them here.
*/
up->ier = UART_IER_RLSI | UART_IER_RDI | UART_IER_RTOIE | UART_IER_UUE;
......
......@@ -116,7 +116,7 @@ extern void iwmmxt_task_release(struct thread_info *);
/*
* We use bit 30 of the preempt_count to indicate that kernel
* preemption is occuring. See include/asm-arm/hardirq.h.
* preemption is occurring. See include/asm-arm/hardirq.h.
*/
#define PREEMPT_ACTIVE 0x40000000
......
......@@ -27,7 +27,7 @@
#define PV908234 (1 << 1)
/* CA:AGPDMA write request data mismatch with ABC1CL merge */
#define PV895469 (1 << 1)
/* TIO:CA TLB invalidate of written GART entries possibly not occuring in CA*/
/* TIO:CA TLB invalidate of written GART entries possibly not occurring in CA*/
#define PV910244 (1 << 1)
struct tioca_dmamap{
......
......@@ -1064,7 +1064,7 @@ static int update_flag(cpuset_flagbits_t bit, struct cpuset *cs, char *buf)
}
/*
* Frequency meter - How fast is some event occuring?
* Frequency meter - How fast is some event occurring?
*
* These routines manage a digitally filtered, constant time based,
* event frequency meter. There are four routines:
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment