1. 08 Sep, 2016 4 commits
  2. 07 Sep, 2016 8 commits
  3. 05 Sep, 2016 10 commits
  4. 19 Aug, 2016 4 commits
  5. 18 Aug, 2016 5 commits
    • Paolo Bonzini's avatar
      Merge tag 'kvm-arm-for-v4.8-rc3' of... · 2eeb321f
      Paolo Bonzini authored
      Merge tag 'kvm-arm-for-v4.8-rc3' of git://git.kernel.org/pub/scm/linux/kernel/git/kvmarm/kvmarm into HEAD
      KVM/ARM Fixes for v4.8-rc3
      This tag contains the following fixes on top of v4.8-rc1:
       - ITS init issues
       - ITS error handling issues
       - ITS IRQ leakage fix
       - Plug a couple of ITS race conditions
       - An erratum workaround for timers
       - Some removal of misleading use of errors and comments
       - A fix for GICv3 on 32-bit guests
    • Peter Feiner's avatar
      kvm: nVMX: fix nested tsc scaling · c95ba92a
      Peter Feiner authored
      When the host supported TSC scaling, L2 would use a TSC multiplier of
      0, which causes a VM entry failure. Now L2's TSC uses the same
      multiplier as L1.
      Signed-off-by: default avatarPeter Feiner <pfeiner@google.com>
      Signed-off-by: default avatarPaolo Bonzini <pbonzini@redhat.com>
    • Radim Krčmář's avatar
      KVM: nVMX: postpone VMCS changes on MSR_IA32_APICBASE write · dccbfcf5
      Radim Krčmář authored
      If vmcs12 does not intercept APIC_BASE writes, then KVM will handle the
      write with vmcs02 as the current VMCS.
      This will incorrectly apply modifications intended for vmcs01 to vmcs02
      and L2 can use it to gain access to L0's x2APIC registers by disabling
      virtualized x2APIC while using msr bitmap that assumes enabled.
      Postpone execution of vmx_set_virtual_x2apic_mode until vmcs01 is the
      current VMCS.  An alternative solution would temporarily make vmcs01 the
      current VMCS, but it requires more care.
      Fixes: 8d14695f
       ("x86, apicv: add virtual x2apic support")
      Reported-by: default avatarJim Mattson <jmattson@google.com>
      Reviewed-by: default avatarWanpeng Li <wanpeng.li@hotmail.com>
      Signed-off-by: default avatarRadim Krčmář <rkrcmar@redhat.com>
    • Radim Krčmář's avatar
      KVM: nVMX: fix msr bitmaps to prevent L2 from accessing L0 x2APIC · d048c098
      Radim Krčmář authored
      msr bitmap can be used to avoid a VM exit (interception) on guest MSR
      accesses.  In some configurations of VMX controls, the guest can even
      directly access host's x2APIC MSRs.  See SDM 29.5 VIRTUALIZING MSR-BASED
      L2 could read all L0's x2APIC MSRs and write TPR, EOI, and SELF_IPI.
      To do so, L1 would first trick KVM to disable all possible interceptions
      by enabling APICv features and then would turn those features off;
      nested_vmx_merge_msr_bitmap() only disabled interceptions, so VMX would
      not intercept previously enabled MSRs even though they were not safe
      with the new configuration.
      Correctly re-enabling interceptions is not enough as a second bug would
      still allow L1+L2 to access host's MSRs: msr bitmap was shared for all
      VMCSs, so L1 could trigger a race to get the desired combination of msr
      bitmap and VMX controls.
      This fix allocates a msr bitmap for every L1 VCPU, allows only safe
      x2APIC MSRs from L1's msr bitmap, and disables msr bitmaps if they would
      have to intercept everything anyway.
      Fixes: 3af18d9c
       ("KVM: nVMX: Prepare for using hardware MSR bitmap")
      Reported-by: default avatarJim Mattson <jmattson@google.com>
      Suggested-by: default avatarWincy Van <fanwenyi0529@gmail.com>
      Reviewed-by: default avatarWanpeng Li <wanpeng.li@hotmail.com>
      Signed-off-by: default avatarRadim Krčmář <rkrcmar@redhat.com>
    • Linus Torvalds's avatar
      Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net · 184ca823
      Linus Torvalds authored
      Pull networking fixes from David Miller:
       1) Buffers powersave frame test is reversed in cfg80211, fix from Felix
       2) Remove bogus WARN_ON in openvswitch, from Jarno Rajahalme.
       3) Fix some tg3 ethtool logic bugs, and one that would cause no
          interrupts to be generated when rx-coalescing is set to 0.  From
          Satish Baddipadige and Siva Reddy Kallam.
       4) QLCNIC mailbox corruption and napi budget handling fix from Manish
       5) Fix fib_trie logic when walking the trie during /proc/net/route
          output than can access a stale node pointer.  From David Forster.
       6) Several sctp_diag fixes from Phil Sutter.
       7) PAUSE frame handling fixes in mlxsw driver from Ido Schimmel.
       8) Checksum fixup fixes in bpf from Daniel Borkmann.
       9) Memork leaks in nfnetlink, from Liping Zhang.
      10) Use after free in rxrpc, from David Howells.
      11) Use after free in new skb_array code of macvtap driver, from Jason
      12) Calipso resource leak, from Colin Ian King.
      13) mediatek bug fixes (missing stats sync init, etc.) from Sean Wang.
      14) Fix bpf non-linear packet write helpers, from Daniel Borkmann.
      15) Fix lockdep splats in macsec, from Sabrina Dubroca.
      16) hv_netvsc bug fixes from Vitaly Kuznetsov, mostly to do with VF
      17) Various tc-action bug fixes, from CONG Wang.
      * git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (116 commits)
        net_sched: allow flushing tc police actions
        net_sched: unify the init logic for act_police
        net_sched: convert tcf_exts from list to pointer array
        net_sched: move tc offload macros to pkt_cls.h
        net_sched: fix a typo in tc_for_each_action()
        net_sched: remove an unnecessary list_del()
        net_sched: remove the leftover cleanup_a()
        mlxsw: spectrum: Allow packets to be trapped from any PG
        mlxsw: spectrum: Unmap 802.1Q FID before destroying it
        mlxsw: spectrum: Add missing rollbacks in error path
        mlxsw: reg: Fix missing op field fill-up
        mlxsw: spectrum: Trap loop-backed packets
        mlxsw: spectrum: Add missing packet traps
        mlxsw: spectrum: Mark port as active before registering it
        mlxsw: spectrum: Create PVID vPort before registering netdevice
        mlxsw: spectrum: Remove redundant errors from the code
        mlxsw: spectrum: Don't return upon error in removal path
        i40e: check for and deal with non-contiguous TCs
        ixgbe: Re-enable ability to toggle VLAN filtering
        ixgbe: Force VLNCTRL.VFE to be set in all VMDq paths
  6. 17 Aug, 2016 9 commits