diff --git a/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts b/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
index d597112f1d5b8ee0b6a4fa17086c8671a5102583..cb5990df6ccb9753d1988b67ac00866fcf72f460 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
@@ -5,6 +5,7 @@
 #include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/leds/common.h>
 #include <dt-bindings/soc/rockchip,vop2.h>
+#include <dt-bindings/usb/pd.h>
 #include "rk3588.dtsi"
 
 / {
@@ -84,6 +85,15 @@ rfkill-bt {
 		shutdown-gpios = <&gpio3 RK_PD5 GPIO_ACTIVE_HIGH>;
 	};
 
+	vcc12v_dcin: regulator-vcc12v-dcin {
+		compatible = "regulator-fixed";
+		regulator-name = "vcc12v_dcin";
+		regulator-always-on;
+		regulator-boot-on;
+		regulator-min-microvolt = <12000000>;
+		regulator-max-microvolt = <12000000>;
+	};
+
 	vcc3v3_pcie2x1l0: regulator-vcc3v3-pcie2x1l0 {
 		compatible = "regulator-fixed";
 		enable-active-high;
@@ -142,6 +152,7 @@ vcc5v0_sys: regulator-vcc5v0-sys {
 		regulator-boot-on;
 		regulator-min-microvolt = <5000000>;
 		regulator-max-microvolt = <5000000>;
+		vin-supply = <&vcc12v_dcin>;
 	};
 
 	vcc_1v1_nldo_s3: regulator-vcc-1v1-nldo-s3 {
@@ -264,6 +275,67 @@ regulator-state-mem {
 	};
 };
 
+&i2c4 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&i2c4m1_xfer>;
+	status = "okay";
+
+	usbc0: usb-typec@22 {
+		compatible = "fcs,fusb302";
+		reg = <0x22>;
+		interrupt-parent = <&gpio3>;
+		interrupts = <RK_PB4 IRQ_TYPE_LEVEL_LOW>;
+		pinctrl-names = "default";
+		pinctrl-0 = <&usbc0_int>;
+		vbus-supply = <&vcc12v_dcin>;
+		/*
+		 * When the board is starting to send power-delivery messages
+		 * too late (5 seconds according to the specification), the
+		 * power-supply reacts with a hard-reset. That removes the
+		 * power from VBUS for some time, which resets te whole board.
+		 */
+		status = "fail";
+
+		usb_con: connector {
+			compatible = "usb-c-connector";
+			label = "USB-C";
+			data-role = "dual";
+			power-role = "sink";
+			try-power-role = "sink";
+			op-sink-microwatt = <1000000>;
+			sink-pdos =
+				<PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)>,
+				<PDO_VAR(5000, 20000, 5000)>;
+
+			ports {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				port@0 {
+					reg = <0>;
+					usbc0_role_sw: endpoint {
+						remote-endpoint = <&dwc3_0_role_switch>;
+					};
+				};
+
+				port@1 {
+					reg = <1>;
+					usbc0_orien_sw: endpoint {
+						remote-endpoint = <&usbdp_phy0_orientation_switch>;
+					};
+				};
+
+				port@2 {
+					reg = <2>;
+					dp_altmode_mux: endpoint {
+						remote-endpoint = <&usbdp_phy0_dp_altmode_mux>;
+					};
+				};
+			};
+		};
+	};
+};
+
 &i2c6 {
 	status = "okay";
 
@@ -423,6 +495,10 @@ usb {
 		vcc5v0_host_en: vcc5v0-host-en {
 			rockchip,pins = <4 RK_PB0 RK_FUNC_GPIO &pcfg_pull_none>;
 		};
+
+		usbc0_int: usbc0-int {
+			rockchip,pins = <3 RK_PB4 RK_FUNC_GPIO &pcfg_pull_none>;
+		};
 	};
 };
 
@@ -835,6 +911,14 @@ &uart2 {
 	status = "okay";
 };
 
+&u2phy0 {
+	status = "okay";
+};
+
+&u2phy0_otg {
+	status = "okay";
+};
+
 &u2phy1 {
 	status = "okay";
 };
@@ -866,6 +950,29 @@ &usbdp_phy1 {
 	status = "okay";
 };
 
+&usbdp_phy0 {
+	mode-switch;
+	orientation-switch;
+	sbu1-dc-gpios = <&gpio4 RK_PA6 GPIO_ACTIVE_HIGH>;
+	sbu2-dc-gpios = <&gpio4 RK_PA7 GPIO_ACTIVE_HIGH>;
+	status = "okay";
+
+	port {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		usbdp_phy0_orientation_switch: endpoint@0 {
+			reg = <0>;
+			remote-endpoint = <&usbc0_orien_sw>;
+		};
+
+		usbdp_phy0_dp_altmode_mux: endpoint@1 {
+			reg = <1>;
+			remote-endpoint = <&dp_altmode_mux>;
+		};
+	};
+};
+
 &usb_host0_ehci {
 	status = "okay";
 };
@@ -874,6 +981,20 @@ &usb_host0_ohci {
 	status = "okay";
 };
 
+&usb_host0_xhci {
+	usb-role-switch;
+	status = "okay";
+
+	port {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		dwc3_0_role_switch: endpoint {
+			remote-endpoint = <&usbc0_role_sw>;
+		};
+	};
+};
+
 &usb_host1_ehci {
 	status = "okay";
 };