OMAP3: CM-T35: Use generic MMC driver

Switch from the legacy omap3 mmc driver to the new generic omap hsmmc
driver.  This patch is based on the work done for Beagle, etc.

Signed-off-by: Tom Rini <trini@ti.com>
Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>

board/cm_t35/cm_t35.c

@@ -313,6 +313,14 @@ void set_muxconf_regs(void)
 		cm_t3730_set_muxconf();
 }
 
+#ifdef CONFIG_GENERIC_MMC
+int board_mmc_init(bd_t *bis)
+{
+	omap_mmc_init(0);
+	return 0;
+}
+#endif
+
 /*
  * Routine: setup_net_chip_gmpc
  * Description: Setting up the configuration GPMC registers specific to the

include/configs/cm_t35.h

@@ -108,8 +108,9 @@
 #define CONFIG_BAUDRATE			115200
 #define CONFIG_SYS_BAUDRATE_TABLE	{4800, 9600, 19200, 38400, 57600,\
 					115200}
+#define CONFIG_GENERIC_MMC		1
 #define CONFIG_MMC			1
-#define CONFIG_OMAP3_MMC		1
+#define CONFIG_OMAP_HSMMC		1
 #define CONFIG_DOS_PARTITION		1
 
 /* DDR - I use Micron DDR */