board: gdsys: Configure bridge on DP501 to support DDC only

The I2C bridge on DP501 supports EDID, MCCS and HDCP by default.
Allow EDID only to avoid I2C address conflicts.

Signed-off-by: Dirk Eibach <dirk.eibach@gdsys.cc>

board/gdsys/common/dp501.c

@@ -54,6 +54,7 @@ static void dp501_link_training(u8 addr)
 void dp501_powerup(u8 addr)
 {
 	dp501_clrbits(addr, 0x0a, 0x30); /* power on encoder */
+	dp501_setbits(addr, 0x0a, 0x0e); /* block HDCP and MCCS on I2C bride*/
 	i2c_reg_write(addr, 0x27, 0x30); /* Hardware auto detect DVO timing */
 	dp501_setbits(addr, 0x72, 0x80); /* DPCD read enable */
 	dp501_setbits(addr, 0x30, 0x20); /* RS polynomial select */

include/configs/controlcenterd.h

@@ -199,9 +199,10 @@
 #define CONFIG_SYS_FSL_I2C2_SPEED	400000
 #define CONFIG_SYS_FSL_I2C2_SLAVE	0x7F
 #define CONFIG_SYS_FSL_I2C2_OFFSET	0x3100
-/* Probing DP501 I2C-Bridge will hang */
-#define CONFIG_SYS_I2C_NOPROBES		{ {0, 0x30}, {0, 0x37}, {0, 0x3a}, \
-					  {0, 0x3b}, {0, 0x50} }
+
+#ifndef CONFIG_TRAILBLAZER
+#define CONFIG_CMD_I2C
+#endif
 
 #define CONFIG_PCA9698			/* NXP PCA9698 */