Only one board uses this driver (ns9750dev), but the board doesn't seem
to have an entry to actually build it in the Makefile/boards.cfg, so just
delete net support from its board config.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

Everyone seems to have converted to the new enc28j60 driver, so drop
this older one which isn't used and doesn't support NET_MULTI.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

The call to run_post(POST_ROM) which can run the POST memory test
is currently called too late when gd has already been copied to DRAM.

This results in failure to boot Linux after a POST_ROM memory test
tested all RAM while gd was already relocated to DRAM due to gd being
overwritten by the POST_ROM memory test.

Support this by moving the call to run_post(POST_ROM) to run earlier,
before U-Boot has started to move data to DRAM (from late board_init_f
to early board_init_f) where DRAM is initialized, but not used yet.

This allows that an POST memory test can test the whole DRAM,
including the area where the board info struct is located.

Signed-off-by: Bernhard Kaindl <bernhard.kaindl@thalesgroup.com>
Cc: Pieter Voorthuijsen <pieter.voorthuijsen@prodrive.nl>

net/dns.c used endian conversion macros wrongly (shorts in reply
were put swapped into CPU, and then ntohs() was used to swap it
back, which broke on big-endian).

Fix this by using the correct linux conversion macro for reading
a unaligned short in network byte order: get_unaligned_be16()
Thanks to Mike Frysinger pointing at the best macro to use.

Tested on big and little endian qemu boards (mips and versatile)

Signed-off-by: Bernhard Kaindl <bernhard.kaindl@thalesgroup.com>
Cc: Pieter Voorthuijsen <pieter.voorthuijsen@prodrive.nl>
Cc: Robin Getz <rgetz@blackfin.uclinux.org>
Acked-by: Mike Frysinger <vapier@gentoo.org>

This changes the board code to use the new getenv_ulong() function.

Signed-off-by: Simon Glass <sjg@chromium.org>

This changes the board code to use the new getenv_ulong() function.

Signed-off-by: Simon Glass <sjg@chromium.org>

This changes the board code to use the new getenv_ulong() function.

Signed-off-by: Simon Glass <sjg@chromium.org>
Acked-by: Stefan Roese <sr@denx.de>

This changes the board code to use the new getenv_ulong() function.

Signed-off-by: Simon Glass <sjg@chromium.org>

This changes the board code to use the new getenv_ulong() function.

Signed-off-by: Simon Glass <sjg@chromium.org>

This changes the board code to use the new getenv_ulong() function.

Signed-off-by: Simon Glass <sjg@chromium.org>

This changes the board code to use the new getenv_ulong() function.

Signed-off-by: Simon Glass <sjg@chromium.org>
Acked-by: Mike Frysinger <vapier@gentoo.org>

This changes the board code to use the new getenv_ulong() function.

Signed-off-by: Simon Glass <sjg@chromium.org>

This changes the board code to use the new getenv_ulong() function.

Signed-off-by: Simon Glass <sjg@chromium.org>

This is not an uncommon operation in U-Boot, so let's put it in a common
function.

Signed-off-by: Simon Glass <sjg@chromium.org>
Acked-by: Mike Frysinger <vapier@gentoo.org>

In commit fa28bd2e patch v1 was applied
instead of v2. This is an incremental patch to update that commit
to version 2.

Signed-off-by: Daniel Schwierzeck <daniel.schwierzeck@googlemail.com>

Init RX/TX ping pong directly from board not in the driver.

Signed-off-by: Michal Simek <monstr@monstr.eu>

Baseaddr should be unsigned long.

Signed-off-by: Michal Simek <monstr@monstr.eu>

commit 8d3fcb5e breaks post
memory support for sdram base != 0x00000000. Fix this.

Signed-off-by: Heiko Schocher <hs@denx.de>
Cc: Valentin Longchamp <valentin.longchamp@keymile.com>
Cc: Holger Brunck <holger.brunck@keymile.com>
Acked-by: Mike Frysinger <vapier@gentoo.org>

Signed-off-by: Shaohui Xie <Shaohui.Xie@freescale.com>

ARCH_DMA_MINALIGN will be used to allocate DMA buffers that are
aligned correctly.  In all current cases this means that the DMA
buffer will be aligned to at least the L1 data cache line size of
the configured architecture.  If the board configuration file
does not specify the architecture L1 data cache line size then the
maximum line size of the architecture is used to align DMA buffers.

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Wolfgang Denk <wd@denx.de>
Cc: Stefano Babic <sbabic@denx.de>
Cc: Ilya Yanok <yanok@emcraft.com>
Cc: Laurence Withers <lwithers@guralp.com>

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Graeme Russ <graeme.russ@gmail.com>

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Shinya Kuribayashi <skuribay@pobox.com>

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Michal Simek <monstr@monstr.eu>

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Reinhard Meyer <u-boot@emk-elektronik.de>

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Daniel Hellstrom <daniel@gaisler.com>

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Acked-by: Stefan Roese <sr@denx.de>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Wolfgang Denk <wd@denx.de>
Cc: Stefan Roese <sr@denx.de>

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Scott McNutt <smcnutt@psyent.com>

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Jason Jin <jason.jin@freescale.com>

Signed-off-by: Anton Staaf <robotboy@chromium.org>
Cc: Mike Frysinger <vapier@gentoo.org>
Cc: Lukasz Majewski <l.majewski@samsung.com>
Cc: Albert ARIBAUD <albert.u.boot@aribaud.net>

This removes most checkpatch warnings from the ns16550 driver and its
header.

Signed-off-by: Simon Glass <sjg@chromium.org>

The board stopped building some time ago, and the board maintainer
agrtees to drop it - see
http://article.gmane.org/gmane.comp.boot-loaders.u-boot/112674



Signed-off-by: Wolfgang Denk <wd@denx.de>
Cc: Alex Dubov <oakad@yahoo.com>
Cc: Andy Fleming <afleming@gmail.com>
Cc: Kumar Gala <galak@kernel.crashing.org>

Do not setup userial_ports array as const because
in uartlite_serial_putc is out_be32 which can't write
to tx_fifo if is const.

Warning log:
serial_xuartlite.c: In function 'uartlite_serial_putc':
serial_xuartlite.c:60: warning: initialization discards qualifiers from pointer target type
serial_xuartlite.c: In function 'uartlite_serial_getc':
serial_xuartlite.c:78: warning: initialization discards qualifiers from pointer target type
serial_xuartlite.c: In function 'uartlite_serial_tstc':
serial_xuartlite.c:87: warning: initialization discards qualifiers from pointer target type

Signed-off-by: Michal Simek <monstr@monstr.eu>

Our boards rely on dtt for initialization of fan hardware.
dtt_init() was implemented to be called form board specific code.

Signed-off-by: Dirk Eibach <eibach@gdsys.de>
Acked-by: Heiko Schocher <hs@denx.de>
Tested-by: Heiko Schocher <hs@denx.de>

Remove MK_STR from places that consume CONFIG_BOOTFILE to force all definitions to be string literals.

Signed-off-by: Joe Hershberger <joe.hershberger@ni.com>
Cc: Joe Hershberger <joe.hershberger@gmail.com>
Cc: Wolfgang Denk <wd@denx.de>
Acked-by: Mike Frysinger <vapier@gentoo.org>

Remove MK_STR from places that consume CONFIG_ROOTPATH to force all definitions to be string literals.

Signed-off-by: Joe Hershberger <joe.hershberger@ni.com>
Cc: Joe Hershberger <joe.hershberger@gmail.com>
Cc: Wolfgang Denk <wd@denx.de>
Acked-by: Mike Frysinger <vapier@gentoo.org>

The current autoconf.mk.dep rule uses the host cflags when executing the
target compiler (which includes target header files).  We don't want to
mix the target compiler and host compiler flags, so change it to CFLAGS.
Otherwise we get things like -pedantic which the U-Boot source code does
not build with.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

People keep adding new code that still uses $(AR) instead of
$(cmd_link_o_target), so turn it into a build time error.

We still use $(AR) locally, but we don't use $(ARFLAGS).

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

Seems people fixed their files to use libfoo.o, but didn't actually
update the creation targets to use $(cmd_link_o_target).  Update the
rest of the Makefile's found with grep.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Tested-by: Simon Glass <sjg@chromium.org>

SPL builds could leave an MLO which is an mkimage of type omapimage
Make sure its deleted on make clean/distclean

Signed-off-by: Joel A Fernandes <joelagnel@ti.com>